The Split Jacquard Recliner Cover

What this recliner cover set is

The Split Jacquard Recliner Cover is a four piece set that dresses a recliner chair in a stretch jacquard weave. Instead of one big slipcover, each part of the chair gets its own piece: one for the back, one for the front, and one for each arm. That split design is what makes the fit work on a recliner, where the back, seat and arms move and sit at different angles.

The fabric is 100 percent polyester jacquard at about 350 gsm. It has a textured weave and a soft hand, so it feels good against skin and holds its shape when stretched over the chair. The jacquard pattern gives the surface a quiet, raised look that reads as fabric, not plastic.

This set is not waterproof. It is a fabric cover, so it handles everyday dust, crumbs and light wear, not spills that soak through.

Sizes and fit

One size covers most standard recliners. Check your chair against these numbers before you order.

Measure the width across the back of the chair, the depth from front to back, and the height from the floor to the top of the back. If your chair lands inside those ranges, this set is built for it. The stretch weave gives some room on either side of the listed numbers, but a chair far outside them will not fit well.

Colors

Nine colors are available, so you can match a chair to the room or give an old recliner a fresh look:

• Beige
• Khaki
• Gray
• Black
• Coffee
• Green
• Navy blue
• Dark gray
• Burgundy

Neutrals like Beige, Khaki, Gray and Dark gray blend into most living rooms. Black and Navy blue hide marks well in busy rooms. Coffee, Green and Burgundy add a warmer or deeper tone.

How to put it on

Each piece is separate and goes on its matching part of the chair. Take the back piece and pull it over the backrest, then the front piece over the seat and footrest area, then the left and right arm pieces over their arms. Work from the top down and tuck the edges in as you go.

Because the pieces are separate, the cover moves with the recliner. When you raise the footrest or lean the back, each section follows its own part instead of pulling against the others. Smooth the fabric with your hands after fitting and push any extra fabric into the gaps at the sides and back.

A note on the fit: this is a stretch cover, not a tailored upholstery job. It will look close and neat on a chair that matches the size range, and it will show folds on a chair that is much smaller. That is normal for a stretch set.

Care

Machine wash at 30°C (86°F) on a gentle cycle, then air dry. Wash the four pieces together so they wear at the same rate. The polyester jacquard holds its color and texture well with regular gentle washing.

For everyday upkeep, vacuum the cover with a brush attachment or shake it out. Spot clean small marks with a damp cloth and mild soap, then let the piece air dry before putting it back on the chair.

What is in the box

Each set includes four covers: 1 back piece, 1 front piece, 1 left arm piece and 1 right arm piece. That is one full set for one recliner chair. If you have two recliners, order two sets.