The Cable Jacquard Coral Fleece Throw

What it is

The Cable Jacquard Coral Fleece Throw is a single-layer blanket made from 100% polyester coral fleece. The fabric is woven jacquard, which builds the raised cable pattern into the cloth rather than printing it on top. A soft brushed finish gives the fleece its smooth, cozy hand feel.

The blanket is rectangular and made for winter. It is lightweight enough to fold and carry, so it works as a nap blanket, a bed cover or a layer over a sofa. Color may vary slightly from photos.

Sizes

Six sizes cover everything from a lap throw to a full bed topper. Measurements are listed in inches first, with the metric value in brackets.

If you want a throw that drapes past the edge of a couch, size up. For a neat fold at the foot of a bed, the 59 x 79 in (59 x 78.5 in) size is a good middle ground.

Colors

Seven colors let you match the blanket to a room or a mood:

• Sage Green: muted and earthy, pairs well with wood and linen
• Light Gray: a clean neutral for bright rooms
• Yellow: a warm pop against dark furniture
• Pink: soft and bright, good for a bedroom
• Beige: a quiet, sandy neutral
• Cream: light and airy, close to white
• Dark Gray: grounded and forgiving in busy rooms

Because the fleece is brushed, each color reads slightly different in daylight and lamplight. Expect small shifts in tone from screen to screen.

How to use it

The throw is multi-purpose by design. Keep one on the arm of a sofa for movie nights. Fold a larger size across the foot of a bed as a layer you can pull up on cold nights. The smaller sizes travel well for picnics, road trips and flights, and they work in a hospital or hotel room when you want your own blanket.

The raised cable pattern adds texture without weight, so the blanket sits smoothly over a couch or chair. It also layers under or over a duvet without feeling bulky.

Care

Machine wash at 30°C (86°F) on a gentle cycle. Tumble dry low. The fleece has a color fastness grade of 3-4, so wash it with similar colors and avoid hot water. Do not iron the brushed surface. A quick shake after drying helps the cable pattern sit evenly again.